Who can damage the Industrial Motherboard?

The human fault of the Industrial Motherboard is mainly caused by human error, external interference or bad environment, and malfunction caused by improper operation of the user.

1. Static Factors

There is usually static electricity on the hands, especially wearing Chinese fiber clothing is prone to high-voltage static electricity. If the static electricity on the handle is removed when disassembling or repairing the motherboard, it is likely to cause the chip on the Industrial Motherboard to burn out. The way to get rid of static electricity on your hands is to put your hands on the radiator to discharge static electricity. If professional equipment is fully equipped, anti-static gloves should be used.

2. Improper Installation

Improper installation and operation causes damage to the Industrial Motherboard. If the operation is reversed when installing the memory module, it will not be inserted into the memory slot. If the power is too strong, the memory and the memory slot of the Industrial Motherboard may be damaged. Even the Industrial Motherboard is deformed, causing the line on the Industrial Motherboard to break.

In addition, you should pay attention to the same problem when installing display cards, sound cards, memory, and data cables, that is, control the strength during installation.

The correct method should be to use two hands to cross the memory strips on both sides. The buckles on both ends of the memory slot will automatically snap into the buckle of the memory stick, and finally insert the memory stick into the memory slot.

3. Hot Plug Failure

On the Industrial Motherboard, in addition to the USB interface and the IEEE1394 interface, it is hard to avoid hot swapping of other peripheral interfaces. When the user uses or debugs the computer, the card on the industrial computer motherboard, such as the keyboard, mouse, printer, etc., is often plugged and unplugged without power failure, and the Industrial Motherboard is burned out. In addition, after turning off the computer power switch, wait 10 seconds before turning it on. If you turn it on immediately after shutdown, it is also more likely to cause damage to the Industrial Motherboard.

4. Faults caused by environmental factors

Poor environmental factors during industrial computer operation can also cause the Industrial Motherboard to malfunction. For example, the environment in which the industrial computer is working is excessively dry or highly humid, and a large amount of dust is accumulated inside the Industrial Motherboard, which directly affects the performance and service life of the industrial computer.

When the external environment is highly dry, static electricity is accumulated in the industrial computer chassis, causing some chips on the Industrial Motherboard to be broken down, especially CMOS chips; when the external environment is wet, the local circuit and components of the Industrial Motherboard are short-circuited, and the acceleration element The device is aging, causing serious failure of the Industrial Motherboard.

In addition, if the external power supply of the computer is unstable, the ATX power supply is damaged, or the spike of the grid voltage is instantaneous, the chip related to the power supply circuit of the Industrial Motherboard is often damaged, and the Industrial Motherboard is faulty.